Graf Brass Blade Bolt

Product description

Graf blade mounting bolts.  For the Graf Ultra holders.  These are the female ends that go onto the back of the Graf Ultra holders.  It is possible you may need the Graf Bolt washers too, as some of the Graf holders are slightly different inside the channel, and some spacing may be required.  Best to grab some washers too to be safe.  (available below)  

Use a flat head screwdriver to install.

Measure your old Brass hardware, and choose the right size you need!

Short - these are 12mm from thread tip to bottom of flush head, 15mm to top of head.

Long - these are 17mm from thread tip to bottom of flush head, 23mm to top of head.