GRAF SKATE HOLDER - ULTRA 5000/NT 3000

Product description

Original - NOS (New Old Stock)

These holders are all originals from the late 90's to early 2000's.

Still NEW - but may have some shelf wear, dirt etc...We will clean them up a bit before shipping, but expect to receive a slightly beat up but new holder!

Ultra 5000 and NT 3000 fit the ULTRA blades, and use the same hole pattern.  Standard on 95% of Graf skates in the 90's and early 2000's.  

NOTE : It is quite possible (if you know anything about Graf hand made skates from this era) That one or two holes may not match up on replacement holders.  Graf was infamous for "custom" drilling holders and not all holes match on replacements.  We have found that MOST holders and holes match up...but we have to tell you...they may not ALL match.  Your local skate shop can drill and fit as needed.  Just the way Graf was back then!